Tag Archives: Waterjet Operation

Control Panel The Introduction of Panel Function Power indicator Turn on the power supply, and release all the E-stop buttons. The indicator lights up in red. It indicates that the extra-high pressure pump can be operated. Remote E-stop refers to the device that installed the remote system.

Waterjet Operation

Control Panel The Introduction of Panel Function Power indicator Turn on the power supply, and release all the E-stop buttons. The indicator lights up in red. It indicates that the extra-high pressure pump can be operated. Remote E-stop refers to the device that installed the remote system. Alarm When the alarm light is up (red), […]

Waterjet Maintenance and Repairing

1. It is needed to prepare and bend the high pressure tube before installation. Bending radius should not be too small. 2. When install a high-pressure nut, it is required to clean the threads first. There can’t be sand and other dirt on it. Then put some blue goop on it. 3. When tighten the […]

Water Jet Safety System

Safety of Electrical System Lock out power before maintenance. Before starting maintenance, please shut down the main power circuit breaker. Non-professional personnel shall not operate if there is any warning tag. When replacing wires, use original wire sizes, types, and the same color. Turn on the electrical switch after maintenance. Close the cover before restart […]

Water Jet Personnel Safety

Water Jet Personnel Safety All water jet cutting equipment operation, maintenance personnel or the equipment shall comply with the following safety precautions. Operation and maintenance personnel must be well trained. And the personnel should obtain the qualified certificate. Operators should always implement the safety requirements, avoiding the possibility of personal injury and unnecessary equipment downtime. […]

Waterjet Cutting High Pressure Water Test

High Pressure Water Test Install the on/off valve in the cutting head; keep the valve open during the test. Make sure the pump stop device operates normally before test. The main purpose of high pressure water test is to remove impurities and build up the sealing system in order to make the high pressure sealing […]

Waterjet Cutting Electrical System

Sensor and Solenoid Valve The sensors monitor the working situation. The electronic control solenoid valve provides basic switch control functions to the intensifier. All the cable connecting the sensor and solenoid valve are tied together. 1. Temperature sensor When the oil temperature goes over 55°C, it should be manually shut down. 2. right/left approach switch […]

Waterjet Low Pressure Water System

Waterjet Low Pressure Water System Cutting water inlet system provides cutting water flow and pressure to the intensifier. The low pressure inlet water system components include input water filter components and booster pump. Connected to the PLC with the pressure switches and temperature switches, it can monitor the inlet cutting water condition. If it goes beyond […]

High Pressure Water System

Waterjet Working Principle The medium of Intensifier system is hydraulic oil and water. The middle part is the hydraulic oil system. The left and right sides are water system. There is piston in the oil cylinder. The piston is connected by two rods on both sides. The piston cylinder is divided into two pieces. When […]

Waterjet Transportation

There is an uneven weight distribution of weight in ultra-high pressure pump on both ends, especially high power type ultra-high pressure pump. Don’t forklift equipment from any end of the ultra-high pressure pump equipment. Find the position of the forklift according to the center gravity of the pump. After removing ultra-high pressure pump from the […]

Waterjet Installation

In this section, there will be details of waterjet installation requirements and procedures. These operating rules require thorough understanding to all of the components, the operation system, the intensifier and the safety regulations. Before the waterjet installation and test of ultra‐high pressure pump, all intensifier installation, operation and maintenance must refer to this manual. All-Powerful […]

Waterjet Safety

Waterjet Safety With the development of ultra-high pressure waterjet technology, it is much safer to use waterjet than other equipment. But there will still be safety risks due to the improper use, operation, maintenance or other factors. Therefore, it is very important to learn all the instruction in this manual. Other than the rules in […]

This entry was posted in FAQs and tagged , on .