Tag Archives: Waterjet Working Principle

Water Jet cutting uses an ultra-high pressure stream of water to carry an abrasive grit. The abrasive does the cutting through a mechanical sawing action, leaving a smooth, precision cut surface.

Cutting Accuracy and Cutting Speed Control of Water Cutter

The waterjet is machined by using ultra-high pressure technology. The waterjet can be used to cut soft-based materials by pressurizing ordinary tap water to 250-400 Mpa pressure, and then spraying it out through a gem nozzle with an inner hole diameter of 0.15-0.35 mm. The high-speed jet with a speed of about 800-1000 m/s can […]

High Pressure Equipment Knowledge

High-pressure abrasive and waterjet cutting systems have unique properties that must be understood to maximize performance and ensure safety. This article discusses the principles of water compressibility and pressurization, metal fatigue, high-pressure plumbing, seals, valves, and making and installing ultrahigh pressure fittings. Abrasive and waterjet cutting equipment operates at pressures up to 60,000 pounds per […]

Waterjet Operation

Control Panel The Introduction of Panel Function Power indicator Turn on the power supply, and release all the E-stop buttons. The indicator lights up in red. It indicates that the extra-high pressure pump can be operated. Remote E-stop refers to the device that installed the remote system. Alarm When the alarm light is up (red), […]

Waterjet Cutting Machine Working Principle

Original Title: Waterjet Cutting Process Basics The most versatile process for shape cutting Highest precision cutting on virtually any material Can be combined with plasma or oxy-fuel on the same part Most versatile cutting process Water Jet cutting uses an ultra-high pressure stream of water to carry an abrasive grit. The abrasive does the cutting through […]

High Pressure Water System

Waterjet Working Principle The medium of Intensifier system is hydraulic oil and water. The middle part is the hydraulic oil system. The left and right sides are water system. There is piston in the oil cylinder. The piston is connected by two rods on both sides. The piston cylinder is divided into two pieces. When […]

How does a waterjet work?

There are two main steps involved in the waterjet cutting process. First the ultra-high pressure pump generally pressurizes normal tap water at pressure levels above 40,000 psi (2760 bar); to produce the energy required for cutting. Second water is then focused through a small precious stone orifice to form an intense cutting stream. The stream […]

This entry was posted in FAQs and tagged , , on .